Is there a way to disable, disconnect, unplug, or remove the Anti-Lock Brake System for a Jeep Cherokee 1989 4WD 4.0L V6 4-Door?|||Either beside the master cylinder or farther down by the frame is the ABS actuator. You can unplug the connector from it, and pull the ABS fuse from the fuse panel. If the light stays on and bothers you you could pull the bulb from the cluster.
To tell if it worked, do you mean if the system does work now? That would be to have a friend watch you as you take the jeep to a empty parking lot where you can get it up to 30+ and slam on the brake really hard and fast to the floor and have him see if the rear wheels lock up at all. If they do lock up and slide then the system is malfunctioning. If they slow down hard and a fraction of a second lock then release and continue to slow down the jeep then they are working fine. If the ABS light is on then the system will not work but the regular braking system will.
To tell if disconnecting the wire to the actuator does the trick? Well once it is not connected the ABS module will not be able to make the actuator work.
If you have any question regarding the system feel free to email me and I will get back with you.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment